FAQ - Frequently Asked Questions
- Products Search > Elemental Analysis
Keyword Search
Frequently Referenced FAQ
FAQ within [ Elemental Analysis ]
-
(ICPS) Element spectrum intensity is high although blank
・Contamination of blank liquid ・Contamination of the torch ・Contamination of the chamber ・Rinsing time is short. Click here for "Check and Replacemen... Show Detail
- No：6785
- Date of Issue：2021/08/19 09:43
- Category： Sequential type(ICPS)
-
(ICPS) E1, E2, E3 error (Auto sampler: AS-9)
E1: A moving erroe of X-axis E2: A moving erroe of Y-axis E3: A moving erroe of Z-axis If above error indication appeared, it is a movement erro... Show Detail
- No：6787
- Date of Issue：2021/08/19 10:14
- Category： Sequential type(ICPS)
-
Please refer to the YouTube URL below. Mounting of the Glassware Parts: https://youtu.be/f-3BMN09U4M Detachment of the Glassware Parts: https://youtu.be/ny... Show Detail
- No：11596
- Date of Issue：2025/01/30 09:29
- Last Updated：2025/01/30 09:32
- Category： ICP Mass Spectrometer (ICP-MS)
-
(ICPE) About internal standard (IS)
Non-spectral interferences may occur when a sample has a high matrix concentration. These include physical interferences and ionization interferences. Physic... Show Detail
- No：12257
- Date of Issue：2026/05/08 13:42
- Category： Multi type(ICPE)
- Brached FAQ
-
(ICPE) Oxygen requirement when introducing an organic sol...
The appropriate approach depends on the measurement requirements and the type of organic solvent. 1. Radial view: Oxygen introduction not required With... Show Detail
- No：12471
- Date of Issue：2026/08/19 09:10
- Last Updated：2026/08/20 12:55
- Category： Multi type(ICPE)
-
(ICPE) How should rinse time be determined?
The following conditions are assumed: ・An AS-10 autosampler is used ・A peristaltic pump is not used ・Sample introduction tube length: 40 cm (See the red l... Show Detail
- No：12473
- Date of Issue：2026/08/19 09:41
- Category： Multi type(ICPE)
- Brached FAQ
-
(ICPE) The limit of quantitation (LOQ)
The limit of quantitation (LOQ) and limit of detection (LOD) are calculated by converting the standard deviation of the intensity of the calibration blank sa... Show Detail
- No：12477
- Date of Issue：2026/08/19 11:30
- Last Updated：2026/08/20 12:57
- Category： Multi type(ICPE)
131-137 of Total 137