FAQ - Frequently Asked Questions
- Products Search > Elemental Analysis
Keyword Search
Frequently Referenced FAQ
FAQ within [ Elemental Analysis ]
-
(ICPE) The limit of quantitation (LOQ)
The limit of quantitation (LOQ) and limit of detection (LOD) are calculated by converting the standard deviation of the intensity of the calibration blank sa... Show Detail
- No：12477
- Date of Issue：2026/08/19 11:30
- Last Updated：2026/08/20 12:57
- Category： Multi type(ICPE)
-
(ICPE) How should rinse time be determined?
The following conditions are assumed: ・An AS-10 autosampler is used ・A peristaltic pump is not used ・Sample introduction tube length: 40 cm (See the red l... Show Detail
- No：12473
- Date of Issue：2026/08/19 09:41
- Category： Multi type(ICPE)
- Brached FAQ
-
(ICPE) Oxygen requirement when introducing an organic sol...
The appropriate approach depends on the measurement requirements and the type of organic solvent. 1. Radial view: Oxygen introduction not required With... Show Detail
- No：12471
- Date of Issue：2026/08/19 09:10
- Last Updated：2026/08/20 12:55
- Category： Multi type(ICPE)
-
(ICPE) About internal standard (IS)
Non-spectral interferences may occur when a sample has a high matrix concentration. These include physical interferences and ionization interferences. Physic... Show Detail
- No：12257
- Date of Issue：2026/05/08 13:42
- Category： Multi type(ICPE)
- Brached FAQ
-
Please refer to the YouTube URL below. Mounting of the Glassware Parts: https://youtu.be/f-3BMN09U4M Detachment of the Glassware Parts: https://youtu.be/ny... Show Detail
- No：11596
- Date of Issue：2025/01/30 09:29
- Last Updated：2025/01/30 09:32
- Category： ICP Mass Spectrometer (ICP-MS)
-
(ICPS) E1, E2, E3 error (Auto sampler: AS-9)
E1: A moving erroe of X-axis E2: A moving erroe of Y-axis E3: A moving erroe of Z-axis If above error indication appeared, it is a movement erro... Show Detail
- No：6787
- Date of Issue：2021/08/19 10:14
- Category： Sequential type(ICPS)
-
(ICPS) Element spectrum intensity is high although blank
・Contamination of blank liquid ・Contamination of the torch ・Contamination of the chamber ・Rinsing time is short. Click here for "Check and Replacemen... Show Detail
- No：6785
- Date of Issue：2021/08/19 09:43
- Category： Sequential type(ICPS)
-
(ICPS) Condensation is found on the RF coil
• Wipe off the water droplets with gauze or some otherappropriate material and ignite the plasma. • Checks that the installation location meets the installa... Show Detail
- No：6783
- Date of Issue：2021/08/19 09:40
- Last Updated：2022/01/17 15:38
- Category： Sequential type(ICPS)
-
(ICPS) Low stability of spectrum intensity
• The ICPSinstallation location does not meet requirements related to installation location or facilities. • One of the causes listed for problem "Spectrum ... Show Detail
- No：6784
- Date of Issue：2021/08/19 09:39
- Last Updated：2022/01/18 09:51
- Category： Sequential type(ICPS)
-
(ICPS) Spectrum intensity much lowers.
・ Deposit adheres the tip of the nebulizer. ・ Deterioration of the nebulizer ・ Deterioration of the sample suction tube ・ Bubble is found into the sample ... Show Detail
- No：6782
- Date of Issue：2021/08/19 09:36
- Category： Sequential type(ICPS)
1-10 of Total 137