FAQ - Frequently Asked Questions
- Products Search > Life Science Lab Instruments
Keyword Search
Life Science Lab Instruments
Frequently Referenced FAQ
FAQ within [ Life Science Lab Instruments ]
-
(MCE) Chip Wash and Probe Rinse
Select the following items from the [Wash] menu, and perform each rinsing operation. • Chip 1 to Chip 4 Washing:Rinse each microchip with water. The n... Show Detail
- No：8335
- Date of Issue：2022/02/15 13:09
- Category： MCE-202(MultiNA)
-
(MCE) Maintenance of Chip Stage and Objective Lens
« Purpose» To clean the chip stage and objective lens. If there is any adhered substance, it may reduce the detection sensitivity. « Guideline... Show Detail
- No：8338
- Date of Issue：2022/02/15 11:54
- Category： MCE-202(MultiNA)
-
(MCE) Maintenance of Sample (Extra Sample) Stand
« Guidelines for Procedure» When adhered substances are present on the sample stand or extra sample stand. « Requirements» • Wipes • Milli... Show Detail
- No：8332
- Date of Issue：2022/02/15 11:54
- Category： MCE-202(MultiNA)
-
(MCE) Maintenance of Chip Cover
« Purpose» To remove any precipitate adhering to the electrode pins on the chip cover and verify that the electrodepins are not bent and the chip pressin... Show Detail
- No：8330
- Date of Issue：2022/02/15 11:54
- Last Updated：2022/02/15 12:53
- Category： MCE-202(MultiNA)
-
(MCE) Maintenance of Air Cylinder Seal
« Purpose» To remove any substances adhered to the air cylinder seal. Salt or other substances adhered to the air cylinder seal will reduce the efficie... Show Detail
- No：8328
- Date of Issue：2022/02/15 11:54
- Category： MCE-202(MultiNA)
-
(MCE) Maintenance of Sample Probe and Aspirator
« Purpose» To remove any substances adhered to the tips of the sample probe and aspirator. Adhered substances may cause the sample probe and aspirator ... Show Detail
- No：8326
- Date of Issue：2022/02/15 11:54
- Category： MCE-202(MultiNA)
-
(MCE) Maintenance of Piercing Needle
« Purpose» To remove any substances adhered to the tip of the piercing needle. Adhered substances may prevent the needle from piercing the aluminum sea... Show Detail
- No：8324
- Date of Issue：2022/02/15 11:54
- Category： MCE-202(MultiNA)
-
(MCE) Moving All Axes to Home Position
When performing inspection and maintenance work, turn ON power to both the instrument and the PC,verify that a connection has been established, and then move... Show Detail
- No：8322
- Date of Issue：2022/02/15 11:43
- Category： MCE-202(MultiNA)
-
1. Turn ON the power switch located on the right side of the MultiNA instrument. The instrument is initialized. The green LED indicator blinks durin... Show Detail
- No：8320
- Date of Issue：2022/02/15 11:10
- Category： MCE-202(MultiNA)
- Brached FAQ
41-49 of Total 49