The f ollowing operations on the controller are not possible while the software is starting:
• Power ON/OFF button
• Function keys (CONDITION, FILE, SET UP)
• [START] and [STOP] keys
• Auto zero button
• Gain button
• Setup changes
• Sampling setup changes
If you cannot connect to the controller, perform the following step s:
1) Exit the software (Select 'File' - 'Exit' from the menu bar.).
2) Disconnect and then reconnect the USB cable.
3) Restart the software.
トラブル1: 名称を設定できないTDがある。
対処・注意1: 接続されていないTDの名称は設定できません。
トラブル2: 言語を変更したが表示が変わらない。
対処・注意2: 使用する言語を変更したときは、 必ず、本ソフトウェアを再起動してください 。変更は再起動後に有効になります。
トラブル3: 位相単位を変更したが表示が変わらない。
対処・注意3: [位相単位]の設定変更は、オプション試験でのみ有効になります。