FAQ - Frequently Asked Questions
- Products Search > Materials Testing & Inspection > Autograph(AG) > EZ-Test Series > (EZ-Test) The test force display indicates "---"
(EZ-Test) The test force display indicates "---"
(EZ-Test) The test force display indicates "---"
- Category :
Answer
• The load cell is not being recognized. Temporarily switch the power OFF and confirm that the calibration cable is connected properly, then switch the power ON again.
• If the display is in [PEAK] value or [BREAK] value mode, values are displayed only after tests are finished.
May I have your opinion?
This site uses the FAQ system "PKSHA FAQ", which is a product of PKSHA Communication Inc.