FAQ - Frequently Asked Questions

  • Font Size
  • S
  • M
  • L
  • No : 6056
  • Date of Issue : 2021/05/18 15:33
  • Last Updated : 2021/06/11 14:53
  • Print

AOCm turret step out[Error Code:6039 6044]

The following causes are possible.
• Turret is not turned to the target position.
• The turret motor, sensor, or encoder has a problem.
Category : 

Answer

Turn off the power, turn the turret gently with your hands, and check the following:
• No cable is caught in the turret's notch.
• No part is interfering with the turret or otherwise applying excessive load on the turret.
• The needle guide is not in contact with any vial.

May I have your opinion?

Please provide your feedback below. This is for feedback only. You will not receive a response.

To Top of Page

This site uses the FAQ system "PKSHA FAQ", which is a product of PKSHA Communication Inc.