• Font Size
  • S
  • M
  • L
  • No : 5412
  • Date of Issue : 2021/03/31 13:39
  • Last Updated : 2022/07/08 14:34

(AA) ASC, Nozzle Position Adjustment

(AA) Nozzle Position Adjustment (ASC-7800/7000)
 
This is for adjusting the nozzle position for sample intake and injection so that sample is correctly drawn from the ASC and injected into the graphite furnace or flame micro sampling method port. Perform the nozzle position adjustment following the messages displayed on the screen step by step. After completing the adjusting operation, click on the [OK] button. Then the next message is displayed and the next operation is prepared at the ASC simultaneously. If you wish to interrupt the nozzle position adjustment procedure, click on the [Cancel] button. However, note that the nozzle position is not recorded if nozzle position adjustment is abandoned part way through.

May I have your opinion?

Please provide your feedback below. This is for feedback only. You will not receive a response.
This site uses the FAQ system "PKSHA FAQ", which is a product of PKSHA Communication Inc.