• Font Size
  • S
  • M
  • L

FAQ within [ Common ]

1-10 of Total 33

1 / 4page
  • (LC) Settings for Fast Analysis (UHPLC)

    1. Setting the Fast LC Mode Fast LC (Mode): Select this for fast gradient analysis, such as when the mobile phase ratio is changed within 3 minutes. This m... Show Detail

    • No:6930
    • Displayed Date:2021/09/10 13:25
  • (LC) Consumable (Connector)

    (Last update: September 6, 2021) (Last update: September 6, 2021) Show Detail

    • No:6916
    • Displayed Date:2021/09/06 16:07
    • Brached FAQ
  • Maintenance for Nexera (LC-40) series...

    Maintenance for Nexera (LC-40) series (Video) Please select a model. •Clich here for Maintenance for LC-40 (Pump) series (Video) - Replacing the... Show Detail

    • No:6633
    • Displayed Date:2021/07/26 13:23
  • (HPLC) Check the Condition of Consuma...

    By executing the system check, you can check the usage of consumables for the entire system. • LCsolution, LabSolutions To open the [System Check... Show Detail

    • No:4965
    • Displayed Date:2021/02/05 10:54
  • (HPLC) Non-injection method (Without ...

    LCsolution, LabSolutions, how to do non-injection when the system includes an autosampler. Vial#:Sets the vial No. of the autosampler to be used for dat... Show Detail

    • No:4925
    • Displayed Date:2021/02/05 10:54
    • Updated DTM:2021/02/09 08:52
  • HPLC: What solvent cannot be used?

    • It is basically used within the pH described in the specifications of the instruction manual of each instruments. • Not covered by warranty if used ... Show Detail

    • No:4633
    • Displayed Date:2020/12/22 13:49
  • HPLC: What solvents cannot be used in...

    Do not use the solvents listed below as the mobile phase when PEEK tubing is used for plumbing. These solvents degrade the strength of the PEEK resin, which ... Show Detail

    • No:4632
    • Displayed Date:2020/12/22 13:22
  • Sawtooth-shaped noise occurs

    Check whether the noise disappears when solvent delivery stops. Check the solvent delivery flow status (pulsation). If pulsation is large, rinse the flow ch... Show Detail

    • No:4300
    • Displayed Date:2020/12/03 11:06
    • Brached FAQ
  • Cyclic spiky noise is output

    Check whether the noise disappears when solvent delivery stops. Check the solvent delivery flow status (pulsation). If pulsation is large, rinse the flow ch... Show Detail

    • No:4299
    • Displayed Date:2020/12/03 11:05
    • Brached FAQ
  • The baseline undulates with the pump ...

    Click [PURGE] to purge the bubbles. Alternatively, connect a syringe to the drain tube connection port to suction out the bubbles. Click here for Manual P... Show Detail

    • No:4296
    • Displayed Date:2020/12/03 11:00
    • Brached FAQ

1-10 of Total 33

This site uses the FAQ system "OKBIZ. for FAQ", which is a product of PRAZNA Inc.