• Font Size
  • S
  • M
  • L

FAQ within [ EHF Series ]

1-10 of Total 28

1 / 3page
  • (EHF) Replacing the Load cell

    1.With the Hydraulic Power Supply stopped, screw the "Screw Rod" into the center of the actuator piston tip. 2.After inserting "Ring Wedge" into "Screw Rod"... Show Detail

    • No:7600
    • Displayed Date:2021/12/08 15:45
    • Brached FAQ
  • (EHF) Test preparation

    1.After starting the Hydraulic Power Supply, press the LOAD key on the front of the control unit. 2.A confirmation screen is displayed on the LCD panel. Pre... Show Detail

    • No:7598
    • Displayed Date:2021/12/08 09:27
    • Brached FAQ
  • (EHF) Boot the test system

    To ensure proper operation of the equipment, check the following before using it. 1.Check that the power cables of the control unit, Hydraulic Power Supply,... Show Detail

    • No:7597
    • Displayed Date:2021/12/08 09:27
    • Brached FAQ
  • (EHF) External alarm cannot be canceled

    If you cannot solve this problem by checking possible causes and taking appropriate actions described below, contact a Shimadzu sales or service representati... Show Detail

    • No:7612
    • Displayed Date:2021/12/07 10:15
  • (EHF) Operation disabled

    If you cannot solve this problem by checking possible causes and taking appropriate actions described below, contact a Shimadzu sales or service representati... Show Detail

    • No:7611
    • Displayed Date:2021/12/07 10:15
  • (EHF) Status indicator does not light

    If you cannot solve this problem by checking possible causes and taking appropriate actions described below, contact a Shimadzu sales or service representati... Show Detail

    • No:7610
    • Displayed Date:2021/12/07 10:15
  • (EHF) Control switching is not possible

    If you cannot solve this problem by checking possible causes and taking appropriate actions described below, contact a Shimadzu sales or service representati... Show Detail

    • No:7608
    • Displayed Date:2021/12/07 10:15
  • (EHF) TD calibration

    Perform TD (transducer) calibration. 1. Pressing the [Calibration] button on the setup screen opens thecalibration menu screen as shownon the right.... Show Detail

    • No:7607
    • Displayed Date:2021/12/07 10:15
    • Updated DTM:2022/01/14 13:01
  • (EHF) Power unit alarm

    If you cannot solve this problem by checking possible causes, contact a Shimadzu sales or service representative. 1. Total Alarm:The power unit has ... Show Detail

    • No:7606
    • Displayed Date:2021/12/07 10:15
  • (EHF) Nothing displayed on the LCD panel

    If you cannot solve this problem by checking possible causes and taking appropriate actions described below, contact a Shimadzu sales or service representati... Show Detail

    • No:7605
    • Displayed Date:2021/12/07 10:15

1-10 of Total 28

This site uses the FAQ system "OKBIZ. for FAQ", which is a product of PKSHA Communication Inc.