FAQ - Frequently Asked Questions

(EHF) Data cannot be added

Data for which the control mode or units are different frompreviously registered data cannot be added. Show Detail

(EHF) I cannot move to another screen from the test metho...

You cannot move to another screen unless at least one step isset up. Show Detail

(EHF) Step settings cannot be configured (combination test)

It is not possible to select a program function test or acombination test. Show Detail

(EHF) A TD cannot be selected in the test method screen

In the max imum value / mean value entry box and the minimumvalue / amp value entry box, a test force TD different from the'Control mode' TD can only be sele... Show Detail

(EHF) Step settings cannot be configured (program functio...

• [Control change]is always set in the first step. This settingcannot be deleted or moved. • An external input waveform can only be used for the final step.... Show Detail

(EHF) The set number of cycles disappears

When the [Unclear set up cycles]checkbox is not selected,cycle numbers set manually in the [Cycle trigger setup] dialogbox and data samp ling table will be c... Show Detail

(EHF) An item cannot be set or selected

• For a static characteristic test, 4 point bend cannot be selected. • The stress is calculated using VTD1 (virtual transducer 1).When VTD1 is in use, this ... Show Detail

(EHF) Dynamic characteristic values cannot be retained

Storage of dynamic characteristic values is possible from thefirst to the 1000th calculation. If the number of dynamiccharacteristic calculations exceeds 100... Show Detail

(EHF) Operation during testing is different from the sett...

• When the step mode is [Auto], [Pause]steps will not be valid. • The test may pause for several seconds at a trig ger output step. • The time until a trig... Show Detail

(EHF) A graph or list cannot be displayed

The peak and characteristic graph appears for the followingtests: • Program function test • Fatigue / Endurance test • Combination test • Frequency s... Show Detail