FAQ - Frequently Asked Questions

Temp. is not controlled [Error Code:9020]

Set [Start Temp/Det] at [Enable] on [GC Start Sequence] screen, start the GC, and then start ignition or illumination again. Show Detail

PURn is not controlled [Error Code:9055 9056 9057 9058]

Set [Septum Purge] to [On] on [Purge Flow Program] screen, and then start the analysis. <GC instrument monitor setting> Press [HOME] &g... Show Detail

SCD furnace temp sensor warn. [Error Code:9075]

The risk of current leakage, heat, smoke, and ignition increases. Turn off the main power of the instrument, stop gas supply, and contact your Shimadzu sa... Show Detail

CARx prim is out of range [Error Code:9063 9064 9065 9066]

Check the amount of remaining gas in the cylinder and tubing. Show Detail

Detector is not controlled [Error Code:9021]

<GC instrument monitor setting> Press [HOME] > [Detector] on GC instrument monitor. Turn [On] the detector control and then start igni... Show Detail

Can not switch gas because of gas selector# sub error occ...

Check whether the sub gas is supplied and whether gas is not leaking from connections. After resolving the problem, press [Reset]. If the error app... Show Detail

Can not switch gas because of gas selector# main error oc...

Check whether the main gas is supplied and whether gas is not leaking from connections. After resolving the problem, press [Reset]. If the error appe... Show Detail

SCD induc. tube use time warn. [Error Code:9076]

Turn off the main power of the instrument, stop gas supply, and contact your Shimadzu sales/service representative to ask for part replacement. Show Detail

SCD detector abs. press is low [Error Code:9080]

Turn off the main power of the instrument, stop gas supply, and contact your Shimadzu sales/service representative. Show Detail

SCD flow controler#2 error [Error Code:6178]

Turn off the main power of the instrument, stop gas supply, and contact your Shimadzu sales/service representative. Show Detail