FAQ - Frequently Asked Questions

Gas Selector# main was overpressure[Error Code:2364 2365]

Check the supply gas pressure. If the supply pressure is correct, turn off the main power of the instrument, stop gas supply, and contact your S... Show Detail

SCD unable to auto start[Error Code:9078]

If a leak check has failed,check the following and perform a leak checkagain. Screen_SCD-Leak-Check.pdf Cause Solution ... Show Detail

SCD exhaust for vacuum error[Error Code:6113]

Determine the cause of the leak by referring to the table below. If the error persists, turn off the main power of the instrument, stop gas supply, and co... Show Detail

SCD furnace abs. press warning[Error Code:9077]

Replace the inner pyrotube. ※Replace the inner pyrotube MaintenanceHelp_SCD-Inner-Pyrotube-Replacement.pdf ※Reset the counter [HOME] - [Det... Show Detail

SCD out pyrotube use time warn.[Error Code:9074]

Replace the outer pyrotube and then reset the counter. ※Replace the outer pyrotube MaintenanceHelp_SCD-Outer-Pyrotube-Replacement.pdf ※Reset... Show Detail

SCD in pyrotube use time warn[Error Code:9073]

Replace the inner pyrotube and then reset the counter. ※Replace the inner pyrotube MaintenanceHelp_SCD-Inner-Pyrotube-Replacement.pdf ※ Rese... Show Detail

Processing, unable to start[Error Code:9054]

Wait for the analysis to finish before starting the next analysis. Show Detail

Not execute this operation [Error Code:9061]

The following operation was executed while theGC stopped. • Ignition/Illumination • FTD Feedback • Start analysis • Batch • Clean Up • PREP RUN • ... Show Detail

SCD ozone scrub. use time warn. [Error Code:9072]

The risk of ozone entering the exhaust from the vacuum pump increases. Replace the filling materials of the ozone scrubber and then reset the counter. ... Show Detail

SCD vacuum pump use time warn. [Error Code:9071]

Replace or maintain the vacuum pump and then reset the counter. SCD vacuum pump replacement MaintenanceHelp_SCD-Vacuum-Pump-Onspection.pdf Cou... Show Detail