• Font Size
  • S
  • M
  • L
  • No : 8106
  • Displayed Date : 2022/02/01 15:39
  • Print

(AGX-V) Attaching a Specimen (Bending Test)

(AGX-V) Attaching a Specimen (Bending Test)
Category : 


1. Adjust the span (5) in the bending test jig.
2. Move the crosshead to a position that allows a specimen to be placed on the bending support base (4) in the jog operation.
3. Place the specimen (1) on the supports (3) in the middle of each support.
  NOTE: Be careful to prevent the bending punch (2) from coming into contact with the specimen (1).
4. Press [Zero reset] of [Force] on the operation screen of the smart controller.

May I have your opinion?

Please provide your feedback below. This is for feedback only. You will not receive a response.
This site uses the FAQ system "OKBIZ. for FAQ", which is a product of PKSHA Communication Inc.