FAQ - Frequently Asked Questions

  • Font Size
  • S
  • M
  • L
  • No : 7928
  • Date of Issue : 2022/01/25 10:49
  • Print

(LCMS) Changing the System Check Pass/Fail Criteria

(LCMS) Changing the System Check Pass/Fail Criteria
Category : 

Answer

System check criteria can be changed by following the procedure below.
Open the [System Configuration] sub-window, select the LCMS system in the [Modules Used for Analysis] area on the right side of the sub-window, and then click [Properties].
The [MS Detector] sub-window is displayed. Click [System Check].
 The [System Check] sub-window is displayed. The consumables check and MS check pass/fail criteria can be changed in this sub-window.
Note: To restore default criteria values, click [Default] in the lower-left area of the sub-window.

May I have your opinion?

Please provide your feedback below. This is for feedback only. You will not receive a response.

To Top of Page

This site uses the FAQ system "PKSHA FAQ", which is a product of PKSHA Communication Inc.