• Font Size
  • S
  • M
  • L
  • No : 7687
  • Date of Issue : 2020/12/02 14:16
  • Last Updated : 2022/01/26 10:33
  • Print

(EZ-Test) The test force display indicates "---"

(EZ-Test) The test force display indicates "---"
Category : 

Answer

• The load cell is not being recognized. Temporarily switch the power OFF and confirm that the calibration cable is connected properly, then switch the power ON again.
• If the display is in [PEAK] value or [BREAK] value mode, values are displayed only after tests are finished.

May I have your opinion?

Please provide your feedback below. This is for feedback only. You will not receive a response.
This site uses the FAQ system "PKSHA FAQ", which is a product of PKSHA Communication Inc.