FAQ - Frequently Asked Questions

  • Font Size
  • S
  • M
  • L
  • No : 3806
  • Date of Issue : 2020/12/02 16:43
  • Print

Error Code:[0x8010]

Error Message: Pump: Pressure failed to reach P.Min, resulting in a purge, but pressure failed to recover, resulting in the stop of pumping. Check the flow paths for leaks, and check the minimum pressure setting.
Category : 

Answer

«Main Cause»
The pump was purged because pressure did not reach the lower pressure limit value, but an error occurred again, so solvent delivery was stopped.
 
«Countermeasure»
Inspect the flow channels for leakage. If no problems are found, reset the [P,Min] value in instrument parameters to an appropriate value.

May I have your opinion?

Please provide your feedback below. This is for feedback only. You will not receive a response.

To Top of Page

This site uses the FAQ system "PKSHA FAQ", which is a product of PKSHA Communication Inc.