FAQ - Frequently Asked Questions
- Products Search > LC-MS > Maintenance
Keyword Search
Frequently Referenced FAQ
FAQ within [ Maintenance ]
-
Maintenance of the Rotary Pump (LCMS)
1. Stop the instrument. 2. Wait about 10 minutes after stopping it. 3. Turn the power OFF at the distribution board to which the rotary pump power cable(1)... Show Detail
- No:3289
- Date of Issue:2020/11/17 09:50
- Last Updated:2022/06/20 13:29
- Brached FAQ
-
Running the instrument while there is a vacuum leak will lead to problems such as reduced sensitivity, increased noise, and breakage of the ion gauge (vacuum... Show Detail
- No:3290
- Date of Issue:2020/11/17 12:48
- Last Updated:2022/06/22 13:00
-
Replacing the Waste Tubes (LCMS)
Waste tubes are fitted at the locations indicated below. If these tubes are particularly soiled, or are damaged, replace them. NOTE: Replace the waste tu... Show Detail
- No:3291
- Date of Issue:2020/11/17 12:52
- Last Updated:2022/06/17 12:42
-
In manual tuning, the instrument can be adjusted manually while monitoring peaks. If peaks cannot be checked while using manual tuning, execute auto tuning i... Show Detail
- No:3293
- Date of Issue:2020/11/18 15:33
- Brached FAQ
-
Carry out auto tuning using the ESI unit/IonFocus Unit to perform sensitivity adjustment, resolution adjustment, and mass calibration of the instrument. Per... Show Detail
- No:3294
- Date of Issue:2020/11/18 15:33
- Brached FAQ
-
•ESI probe /Sub Interface •APCI probe Show Detail
- No:6464
- Date of Issue:2021/06/23 13:46
- Last Updated:2024/09/30 14:24
-
(LCMS) Consumables (Standard Sample)
- No:6466
- Date of Issue:2021/06/23 13:46
- Last Updated:2024/09/30 14:25
-
(LCMS) Consumables (Drain Tube)
- No:6468
- Date of Issue:2021/06/23 13:54
- Last Updated:2024/09/30 14:23
-
(LCMS) Consumables (Rotary Pump Oil)
- No:6470
- Date of Issue:2021/06/23 14:28
- Last Updated:2024/09/30 14:24
-
- No:6472
- Date of Issue:2021/06/23 14:30
- Last Updated:2024/09/30 14:23
11-20 of Total 23