• Font Size
  • S
  • M
  • L

FAQ within [ Universal Testing Machine(UH) ]

11-16 of Total 16

2 / 2page
  • (UH) Lubrication (Greasing)

    1. Apply grease to the screw rods. Be sure to completely remove the old grease before applynew grease. (Monthly) 2. Apply machine oil or spindle oil to ... Show Detail

    • No:7544
    • Date of Issue:2021/12/02 15:17
    • Brached FAQ
  • (UH) Repositioning the Upper Crosshead

    WARNING:Be sure to install the lower fixture so that it is seated correctly in the set ring. The upper fixture may come off during tests if the lower f... Show Detail

    • No:7536
    • Date of Issue:2021/12/02 15:17
    • Brached FAQ
  • (UH) Setting up the touch panel

    Before operating the testing machine, you need to perform the initial setting of the LCD display. The touch panel must be configured so that the keys displa... Show Detail

    • No:7535
    • Date of Issue:2021/12/02 13:38
  • (UH) Raising / Lowering the Table

    Set the Manual mode before manually raising/lowering the table. (Click)Using the load control (Manual Control) knob The load control knob can... Show Detail

    • No:7534
    • Date of Issue:2021/12/02 13:38
  • (UH) Raising / Lowering the Lower Crosshead

    CAUTION:Make sure that there is no obstacle, tools, etc. on the upper or lower surface ofthe crosshead before operating the crosshead. Also, since the ... Show Detail

    • No:7533
    • Date of Issue:2021/12/02 13:38
  • (UH) Starting and Stopping the Machine

    1. Make sure that there are no obstacle around the testing machine, and then turn ON the powerswitch. 2. Turn ON the key switch to supply power. ... Show Detail

    • No:7532
    • Date of Issue:2021/12/02 13:24
    • Brached FAQ

11-16 of Total 16

This site uses the FAQ system "PKSHA FAQ", which is a product of PKSHA Communication Inc.