FAQ - Frequently Asked Questions
Keyword Search
Frequently Referenced FAQ
FAQ within [ Error/Warning ]
-
Settings were changed [Error Code:4301]
If you changed the part which is not executed, the instrument continues the analysis according to the changed program. Check the setting. Show Detail
- No：5884
- Date of Issue：2021/05/18 15:37
- Last Updated：2021/06/04 13:58
-
DET1 2 3 4 BID short-circuit in discharge cell [Error Cod...
Turn off the main power and then turn on the instrument again. If the error occurs repeatedly, cables may be damaged. Turn off the main power of the inst... Show Detail
- No：5883
- Date of Issue：2021/05/18 15:37
- Last Updated：2021/06/04 13:56
-
DAMCn makeup control irregularity [Error Code:2087 2088 2...
Check that the supply pressure to each unit is within the range below. Check that the gas supply pressure is stable. If the error appears rep... Show Detail
- No：5882
- Date of Issue：2021/05/18 15:37
- Last Updated：2021/06/04 13:52
-
xxx temperature controller error [Error Code:1037 1038 10...
Turn off the main power of the instrument, stop gas supply, and contact your Shimadzu sales/service representative. Show Detail
- No：5881
- Date of Issue：2021/05/18 15:37
- Last Updated：2021/06/04 13:51
-
Overheat is sensed [Error Code:1036]
Turn off the main power of the instrument, stop gas supply, and contact your Shimadzu sales/service representative. Show Detail
- No：5880
- Date of Issue：2021/05/18 15:37
- Last Updated：2021/06/04 13:50
-
SCD ozonier voltage fell below lower limit [Error Code:6123]
Turn off the main power of the instrument, stop gas supply, and contact your Shimadzu sales/service representative to ask for part replacement. Show Detail
- No：5879
- Date of Issue：2021/05/18 15:37
- Last Updated：2021/06/04 13:49
-
SCD ozonier voltage was exceeded upper limit [Error Code:...
Turn off the main power of the instrument, stop gas supply, and contact your Shimadzu sales/service representative to ask for part replacement. Show Detail
- No：5878
- Date of Issue：2021/05/18 15:37
- Last Updated：2021/06/04 13:48
-
SCD fan error [Error Code:6121]
Turn off the main power of the instrument, stop gas supply, and contact your Shimadzu sales/service representative to ask for part replacement. Show Detail
- No：5877
- Date of Issue：2021/05/18 15:37
- Last Updated：2021/06/04 13:47
-
TCD signal was out of range [Error Code:4201]
Perform zero adjustment again after the TCD baseline becomes stable. If it does not work, press (HOME)-[Detector] and change to the optimum current value ... Show Detail
- No：5876
- Date of Issue：2021/05/18 15:37
-
DET#1 2 3 4 FTD adjustment failed [Error Code:4149 4150 4...
Check that connection of electrode connector is correct and collector fixing knurled screws are tightened. MaintenanceHelp_FTD-Collector-Replacement.pdf ... Show Detail
- No：5875
- Date of Issue：2021/05/18 15:37
- Last Updated：2021/06/04 14:09
81-90 of Total 221